Samsung SHR-5082 Security Camera User Manual


 
Smart Viewer _59
10 Smart Viewer
3. When audio signal is available, the audio
mark appears.
4.
It displays whether the PTZ controls are
active.
5.
The current channel alarm status is
displayed.
6.
The name and IP address of the connected
DVR are displayed.
Clicking the speaker icon changes the
audio On and Off.
: Audio Off : Audio On
When the audio function is disabled, the
following icon is displayed.
: Audio Disabled
When the alarm or motion is detected,
its status is displayed on the screen in
real time with the corresponding icon.
: Motion Detection : Alarm Event
If you have set PTZ cameras for the
DVR, the PTZ icon is displayed on the
screen. Select a PTZ camera channel
a
nd use the PTZ buttons for control. (For
more information, refer to Chapter 5,
“PTZ Camera Control.”)
Event Log Display Window
Click Log to activate the log display window.
It displays the events such as alarms, connection
events, and setup change events in real time.
The displayed events are:
Connecting..: When trying to connect
to a DVR is in progress.
Connected..: When connection is
made to a DVR.
Connection Failed: When connection
to a DVR fails.
Disconnected..: When the DVR is
disconnected.
Setup (Remote): When any DVR
settings are changed by Smart Viewer.
Setup Start/End (Local): When the
Menu Setup window for the DVR is
started or ended.
Video Loss CH[N]: When a video loss
in a channel is detected.
Time Change: When the date and time
of the DVR are changed.
Load Factory Default: When the DVR
system is initialized.
Network Change: When the DVR
network setup is changed.
System Shutdown: When the DVR
system is terminated.
HDD Format: When the HDD
formatting is initialized.
D
isk Full: When there is no more space
in the HDD of DVR.
Power Failure Recovery: When the
DVR resumes after power failure.
Backup Start/End/Fail/Stop: Backup
f
or the DVR is started, finished, failed, or
stopped.
Network Traffic Busy: Data transport
through the network is not smoothly
going.
Access Denied (Limit Over): No
more access is allowed because the
connection limit is over.
CAUTION
When specific events such as
time change, load factory default,
network change, system shutdown,
or HDD format are detected, Smart
Viewer automatically terminates the
connection.
SHR-5162_Eng.indb 59 2007-06-18 ソタタ・11:50:04