Samsung SNP-5430 Security Camera User Manual


 
Enable SNMP Trap : SNMP trap is used to send important events and conditions
to the Admin.
- Community : Enter the trap community name to receive messages.
- IP address : Enter the IP address to which messages will be sent.
- Authentication failure : It specifies whether an event shall be generated when the
community information is invalid.
- Network connection : It specifies whether an event shall be generated when the
network disconnection is restored.
Enable SNMP v3 : SNMP version 3 will be active.
- Password : Specify the default password for SNMP version 3. The default
password is <admin4321>.
`
The default password can be exposed to a hacking thread so it is recommended to change the
password after installing the product.
Note that the security and other related issues caused by the unchanged password shall be
responsible for the user.
`
Password should be longer than 8 characters, no more than 16 characters.
4. When done, click [Apply (
)].
J
`
SNMP v3 is only able to be set when the secure connection mode is HTTPS.
Refer to “SSL”. (page 105)
`
If you don’t use SNMP v3, there may be a security issue.
Auto IP configure
You can set the IP available for access and camera searching automatically.
1. From the Setup menu, select the
<Network (
)> tab.
2. Click <Auto IP configure>.
3. Set the <Link-Local IPv4 address>.
An additional IP address may be
assigned to assess the camera from
the Link-Local network.
Auto configure : It specifies Able
or Disable for the Link-Local IPv4
address.
IP address : Display the assigned IP
address.
Subnet mask : Display the subnet mask of the assigned IP.
setup screen
108_ setup screen