Samsung SNP-5430 Security Camera User Manual


 
Audio detection
You can set to detect sound over the specified level and trigger an event accordingly.
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <Audio detection>.
3.
Set whether or not to
<
Enable
>
.
4.
Set the audio detection’s sound level.
The lower the level, the smaller the
sound change is detected.
M
`
The audio detection level is designed
to normalize the input data to a value
between 1 and 100 and detect the signal
larger than threshold level. It is unrelated
to the decibel (dB) level.
5.
Specify the activation time and activation
condition.
`
For more information about <Activation time> and <Action>, refer to “Alarm input”. (page 119)
6. When done, click [Apply (
)].
M
`
If detected audio level is too low, set the audio input gain to a higher level in <Audio setup>.
`
You can use the audio detection function when the camera is connected with an audio input
device.
Network disconnection
When the network is physically disconnected, it is considered as an event to be saved.
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <Network disconnection>.
3.
Set whether or not to
<
Enable
>
.
4. Specify the activation time and
activation condition.
`
For more information about <Activation
time> and <Action>, refer to “Alarm input”.
(page 119)
5. When done, click [Apply (
)].
setup screen
130_ setup screen