Filter
Top Products
User’s Manual >>
81
MUST DO for underwater housing:
1. Read and understand the instructions contained in this manual before using
the underwater housing.
2. Do not exceed the depth rating of 60m (200ft.) or the housing may leak.
3. Follow these important O-ring care instructions or the waterproof housing may
leak.
Inspect and clean O-ring and O-ring contact surfaces for sand, hair and
other debris before every use. Clean O-ring and O-ring contact surfaces with
cleaning brush provided in Care Kit.
Inspect O-ring and O-ring contact surfaces for damage (cuts, scratches, tears,
cracks, dents and any other imperfections.) Replace O-ring or have waterproof
housing serviced if the O-ring or O-ring contact surfaces are damaged. Do
not use underwater housing if O-ring or O-ring contact surfaces are
damaged. Replacement O-rings are available at your local authorized SeaLife
dealer.
Make sure O-ring is completely seated into O-ring groove before sealing
housing. O-ring must not be twisted when seated in the O-ring groove.
Carefully follow O-ring removal and installation instructions contained in this
manual.
Replace O-ring every year to ensure proper seal. Only use approved SeaLife
O-ring designed for the DC600.
Soak and rinse waterproof housing in fresh water after each use. Use clean,
soft cloth to dry housing. Store camera and housing only after careful
cleaning and when totally dry.
4. Carefully close lid to seal housing.
Make sure O-ring does not slip out of the groove when sealing.
Make sure there are no obstructions that prevent housing from sealing
properly.
Press lid firmly and tightly down into housing to ensure a waterproof seal.
5. Never let any moisture or dirt get inside housing when opening.
Only open and load the housing in dry cool air, such as inside an air-
conditioned room.
6. For great underwater pictures you need:
Clear water conditions, control your buoyancy before taking pictures, get as
close as possible to subject (ideal distance is 2’ to 6’)
Use SeaLife External Flash to enhance colors and reduce backscatter.
7. Store housing at room temperature in a clean and dry place.
Do not expose housing to direct sunlight for prolonged periods of time.
Do not store housing in extreme high temperatures, such as the trunk of
your car.