Filter
Top Products
User’s Manual >>
83
Maintaining a waterproof seal
Every SeaLife housing is tested for quality and a waterproof seal. It is your
responsibility to properly care for the O-ring and O-ring contact surfaces
to maintain a waterproof seal. Carefully follow these important O-ring care
instructions. Not following these care instructions may cause the waterproof
housing to leak and void your warranty.
1. Carefully inspect O-ring and O-ring contact surfaces for damage (cuts,
scratches, tears, cracks, dents and any other imperfections.) before every use.
Rub finger along O-ring and O-ring contact surfaces to inspect for damage.
Replace O-ring or have waterproof housing serviced if the O-ring or O-ring
contact surfaces are damaged. Do not use underwater housing if O-ring or
O-ring contact surfaces are damaged. Replacement O-rings are available at
your local authorized SeaLife dealer.
Inspect and replace O-ring if damaged: A=Cut, B=Tear, C=Dent
1. Carefully inspect and
clean O-ring and O-ring contact surfaces for
sand, hair and other debris before every use. Clean o-ring and o-ring
contact surfaces with cleaning brush provided in Care Kit.
Inspect and clean O-ring and O-ring contact surface for hair or fibers (#1)
and Sand, Salt or debris (#2)
Clean O-ring and O-ring contact surfaces with brush provided in Care Kit.
3. Make sure O-ring is completely seated into O-ring groove before sealing
housing. O-ring must not be twisted when seated in the o-ring groove. See
page 85 on instructions on how to install and remove O-ring.