Filter
Top Products
4 Camfire PC Installation and User's Guide
Recommended Tools
Have the following tools on hand when you install the Camfire PC system:
• Phillips® No. 2 screwdriver
• bubble level
• measuring tape
• security hex key (supplied)
Mounting a Camera Boom on the Wall
To install multiple camera booms, repeat these instructions for each one.
Step 1: Mark the drywall anchor locations
1. Measure the width of the whiteboard and use a pencil to mark on the wall the center
location of the whiteboard. Make the pencil mark immediately above the top edge of
the whiteboard.
2. Fold the template along the score line, making sure the fold is straight.
3. Rest the folded template on top of the whiteboard and use the diamond-shaped
window to align the template with the center mark above the whiteboard. Make sure
the corner fold is snug against the wall and the top edge of the whiteboard.
NOTE: An electronic version of this template is available at www.smarttech.com/
products/camfire/specs.asp should you misplace the one that was shipped with your
product.
IMPORTANT
Leave at least 17 in. (43 cm) clearance between the top of the
whiteboard and the ceiling.
4. Mark the center locations for the three toggle bolt anchors.
Center of Whiteboard
STEP
1
2
1
Whiteboard
17 in. (43
cm) Minimum
1
STEP
WINDOW
Toggle Bolt
A
nchor Location
A
lignment Window
Camera Boom
Installation
Ceiling
SMA RT Cam Fir e
Camer a B oom Installation Template