Filter
Top Products
8 Camfire PC Installation and User's Guide
To connect the camera booms
1. Begin with the camera boom farthest from the computer.
2. Open the door at the bottom of the camera boom base and connect the IEEE 1394
cable to the Input port.
Be careful to use the correct port. When you’re facing the camera boom, the Input
port is the one on the left.
3. Run the IEEE 1394 cable through the wire management hook and across the top of
the whiteboard to the next camera boom.
You may want to use a raceway to keep the IEEE 1394 cable and any power cables
out of the way. For example, Panduit® Corporation offers LD surface raceways. For
more information, visit the Panduit Corporation Web site at www.panduitncg.com.
4. Open the door on the next camera boom base, connect the other end of the cable
into the Next Boom port and guide the cable through the wire management hook.
When you’re facing the camera boom, the Next Boom port is on the right.
Computer
Location
Next Boom
Port
Next Boom
Port
Input
Port
Input
Port
First Camera Boom Second Camera Boom Third Camera Boom
Figure 2: Connecting the Camera Booms (Computer on the Left)
Next Boom
Port
Next Boom
Port
Input
Port
Input
Port
Computer
Location
First Camera BoomSecond Camera BoomThird Camera Boom
Figure 3: Connecting the Camera Booms (Computer on the Right)
5. For each camera boom, repeat steps 2–4.
6. Close the door on each camera boom base.