Filter
Top Products
16
b Notes
• You cannot charge the battery pack while the
QUICK ON lamp is flashing. When the QUICK
ON lamp is flashing, press POWER to turn off
your camcorder. Make sure the QUICK ON
lamp is not flashing before charging the battery
pack.
• When inserting the camcorder into the
Handycam Station, close the DC IN jack cover.
• Disconnect the AC Adaptor from the DC IN
jack holding both the Handycam Station and the
DC plug.
To remove your camcorder from the
Handycam Station
Close the LCD panel, then remove the
camcorder from the Handycam Station
holding both your camcorder and the
Handycam Station.
To charge the battery pack using only
the AC Adaptor
Close the LCD panel with your camcorder
turns off, then connect the AC Adaptor to
the DC IN jack on your camcorder.
b Notes
• Disconnect the AC Adaptor from the DC IN
jack holding both the camcorder and the DC
plug.
To remove the battery pack
Turn off your camcorder and open the
battery/Memory Stick Duo cover.
Slide the battery eject lever.
Be sure not to drop the battery pack.
b Notes
• When you remove the battery pack or
disconnect the AC Adaptor, make sure that the
(Movie) lamp/ (Still) lamp (p. 19)/
access lamp (p. 21)/QUICK ON lamp are turned
off.
• When you store the battery pack, fully discharge
the battery before storing it for an extended
period (see page 94 for the details of storage).
With the v mark
on the bottom
DC IN jack
Open the jack
cover
DC plug
Battery eject lever