Filter
Top Products
6
Chapter 6 A Quick Lesson on Camera Settings 70HDC-900/950/930 Series Product Information Manual
1. Turn on the power to the MSU-700A/750 while
holding PARA, PANELACTIVE, and camera select
buttons pressed.
The numeric keys appear on the display.
2. Press the [0] [3] [5] [9] of the numeric keys to enter
"0359" in the field for entering the security code,
then press [OK].
The Engineer Protection display now appears.
3. To delete the security code, press [Code Delete].
To temporally disable the security code, press
[Code Enable] to change it from inverse video to
unhighlighted display. (Once you press it again to
return it to inverse video, the security code is
enabled.)
4. As the message "Code Delete, OK?" is displayed, if
you press [Code Delete] in step 3, press [OK] to
return to the Engineer Protection display.
5. Press [Exit].
Note
At the factory, the unit is set in a mode in which no
security code is used.
6-3-2 Setting the Security Status
You can limit the control functions of the MSU-700A/
750 when required. The status setting is enabled in the
Engineer Mode.
Operation
Proceed as follows:
1. Press to light the CONFIG button.
2. Press [MSU]. The MSU Configuration Menu
appears.
3. Press [Security]. The Security Menu display
appears.
4. Press [Engineer Mode] to set it to inverse video.
The numeric keys and field for entering the Code
No. are displayed.
1234567891011
PARA
PANEL
ACTIVE
EXPAND
MULTI
TALLY
WAVEFORM MONITOR CC
0 7 0 8 0 9 1 0 1 1 1 2
0 1 0 2 0 3 0 4 0 5 0 6
PANEL
ACTIVE
PARA
EXPAND
MULTI
TALLY
MULTI
TALLY
PARA button
MSU-700A
MSU-750
Camera select button 1
PANEL ACTIVE button
PARA button
PANEL ACTIVE
button
Camera select
button 1
Engineer Protection
Code
Enable
Protection
Exit
Code
Delete
MODE
MULTI
CARD
CONFIG
MAINTENANCE
FILE
PAINT
Configuration Menu
2
1
MSUCNU
Camera
CCU
Menu operation block(Example:MSU-700A)
Configuration Menu
Security
MSU Configuration
MSU
Adjusting
Exit
Date /
Time
MSU SW
Set
Security Menu
Engineer Mode
Exit
Engineer Mode
OK Cancel
Code No:
987
654
321
0