4-68 Chapter 4 Adjustments and Settings for Recording
4
3 Press the MENU CANCEL/PRST/ITEM switch repeatedly toward
the ITEM position, until the ID (one of ID-1 to ID-4) you wish to set
has the cursor to the left of it (or use the rotary encoder).
When you press the rotary encoder once more, a question mark
appears by the selected ID, and a character position selection cursor
(↓) also appears (the character setting mode).
4 Press the rotary encoder repeatedly until the character position
cursor indicates the character you wish to set.
Each time you press the rotary encoder, the cursor moves one
position to the right. If you press it when the cursor is at the right
end, the cursor disappears, the camcorder exits from the character
setting mode.
5 Turn the rotary encoder until the character you wish to set appears.
Turn the rotary encoder clockwise as seen from the front of the
camera to cycle the character from the alphabet, through space (π),
the symbols, and the digits, in that order. Turn the rotary encoder
counterclockwise to cycle through the characters in the reverse
direction.
It is also possible to enter a space when the character position cursor
(↓) is in the required character position, by pressing the MENU
CANCEL/PRST/ITEM switch toward the CANCEL/PRST position.
To set more characters, go to step 6, and to end character setting go to
step 7.
6 Press the rotary encoder to advance the character position cursor to
the next position, then return to step 5 to set a character.