Filter
Top Products
Chapter 3 Recording and Playback 3-5
3
3-2 Recording
3-2-1 Basic Procedure
This section describes the basic procedure for shooting and recording.
Before a shooting session, make the checks listed in Section 6-1 “Testing
the Camcorder Before Shooting” (page 6-1) to ensure that the camcorder
is functioning properly.
Turning on the camcorder and loading a cassette
Follow the procedure below.
Basic procedure for shooting : from power supply to cassette loading
1 Load a fully charged battery pack.
2 Set the POWER switch to ON. Check that the HUMID indicator
does not appear and that the BATT indicator shows at least five
segments. When using a BP-L60/L90 battery pack, check that the
four LED indicator segments on the battery pack are lit.
• If the HUMID indicator appears, wait until it disappears.
• If the BATT indicator does not show at least five segments,
replace the battery pack with a fully charged one.
3 Check that there are no obstructions near the cassette lid, then press
the EJECT button to open the cassette lid.
(Continued)
4
1
3
2