Chapter 4 Adjustments and Settings for Recording 4-111
4
7 To end the menu operation, set the MENU ON/OFF/PAGE switch to
OFF.
The setup menu disappears from the viewfinder screen and the
displays indicating the current status of the camcorder appear along
the top and bottom of the viewfinder.
If data cannot be read
If when you press the rotary encoder in step 6 of the above procedure
(page 4-110) one of the following error messages appears, then the data
was not read.
Data read error messages
Error message
CARD NOT
INSERTED!
READ ERROR!
(flashing)
CARD DATA NG!
(flashing)
Reason
No setup card is inserted.
Circuit or card fault
The card contains the
data that cannot be read
into this camcorder.
Action
Close the menu and insert
or reinsert the card.
Re-check, and consult a
Sony representative.
Do not try to read the data
written for another
camcorder.
Setting the card ID
When data is written to a setup card, it is useful to set an ID for the card
to identify it.
When data is saved to a card, a card ID is written to the card together
with the data. When data is read from a card, the card ID is also read,
and that ID overwrites the card ID associated with the data that was
previously in the camcorder.
1 Move the cursor to ID EDIT on the SETUP CARD page.
(Continued)