Filter
Top Products
18
Basic Functions
Mode Condition
Basic settings
Mode
Power
Off
1)
Power On
IFC
2)
Initializing
3)
During displaying
the menu
Memory
Command
Command
Address Set
Yes Yes Yes Yes Yes
IF_Clear Yes Yes Yes Yes Yes
CAM_Power On
Yes No No Yes No
CAM_Power Off
Yes No No Yes No
IR_Receive On/Off
No No No Yes
4) 6)
No
IR_ReceiveReturn On/Off
No No No Yes
6)
No
CAM_VersionInq Yes Yes Yes
5)
Yes Yes
CAM_PowerInq Yes Yes Yes Yes Yes
BlockInquiry No No No Yes
6)
No
InquiryCommand (and similar commands)
No No No Yes
6)
No
1) DC power is being supplied, but the camera has been turned off by a VISCA command.
2) The period from the time IF Clear is sent, until the Reply Packet is returned.
3) The period from the time DC power is turned on or the camera is turned on via a VISCA command, and the camera subsequently finishes the pan/tilt reset operation
and stops at the Home position, until the video signal is output. Or the period from the time the CAM Power ON command is sent, until Completion is returned.
4) The camera does not receive the operation sent from the Remote Commander.
5) Commands can be executed after the pan/tilt movement has been started. Before that, camera movement may be inconsistent.
6) When the menu display is updating, operation is not possible.