Filter
Top Products
19
Basic Functions
Zoom/Focus
Mode
Power Off
1)
Power On
Command
IFC
2)
Initializing
3)
Zoom Direct Focus Direct AF ON
During displaying
the menu
Memory Recall
CAM_Zoom Tele/Wide/Stop [VISCA]
No No No No Yes Yes Yes
4)
No
CAM_Zoom Tele/Wide/Stop [RC]
No No No No Yes Yes Yes
4)
No
CAM_Zoom Direct
No No No Yes Yes Yes Yes
4)
No
D-Zoom Limit
No No No No Yes Yes Yes
4)
No
CAM_Focus Far/Near/Stop [VISCA]
No No No Yes No No Yes
4)
No
CAM_Focus Far/Near/Stop [RC]
No No No Yes No No Yes
4)
No
CAM_Focus Direct
No No No Yes Yes No Yes
4)
No
CAM_Focus Mode (Auto/Manual)
No No No Yes No Yes Yes
4)
No
CAM_Focus One Push Trigger
No No No Yes No No Yes
4)
No
CAM_Focus Infinity
No No No Yes No Yes Yes
4)
No
CAM_Focus Near Limit
No No No Yes No Yes Yes
4)
No
AF Sensitivity Normal/Low
No No No Yes Yes Yes Yes
4)
No
AF Mode Norm/Interval/Zoom
No No No Yes Yes Yes Yes
4)
No
AF Activation Time/Interval Setting
No No No Yes Yes Yes Yes
4)
No
1) DC power is being supplied, but the camera has been turned off by a VISCA command.
2) The period from the time IF Clear is sent, until the Reply Packet is returned.
3) The period from the time DC power is turned on or the camera is turned on via a VISCA command, and the camera subsequently finishes the pan/tilt reset operation and stops at the Home position, until the video signal is
output. Or the period from the time the CAM Power ON command is sent, until Completion is returned.
4) When the menu display is updating, operation is not possible.
White Balance
Mode
Power Off
1)
Power On
IFC
2)
Initializing
3)
White balance mode
During displaying
the menu
Memory Recall
Command Auto Indoor Outdoor One Push Manual
CAM_WB Auto/Indoor/Outdoor/
OnePhshWB/Manual
No No No Yes Yes Yes Yes Yes Yes
4)
No
CAM_WB One Push Trigger
No No No No No No Yes
5)
No Yes
4)
No
CAM_WB R(B) Gain
Reset/Up/Down/Direct
No No No No No No No Yes Yes
4)
No
1) DC power is being supplied, but the camera has been turned off by a VISCA command.
2) The period from the time IF Clear is sent, until the Reply Packet is returned.
3) The period from the time DC power is turned on or the camera is turned on via a VISCA command, and the camera subsequently finishes the pan/tilt reset operation and stops at the Home position, until the video signal is
output. Or the period from the time the CAM Power ON command is sent, until Completion is returned.
4) When the menu display is updating, operation is not possible.
5) Commands are ignored during a One Push AWB operation.