Filter
Top Products
[16] How to use Getting Started Using the Waterproof Case
Maintenance
After recording in a location with a sea breeze, wash this unit thoroughly in fresh water with the buckle
fastened to remove salt and sand, then wipe with a soft dry cloth. It is recommended that you
submerge the waterproof case in fresh water for about 30 minutes. If it is left with salt on it, metal
portions may be damaged or rust may form and cause water leakage.
If sun oil is on the waterproof case, be sure to wash it off thoroughly using lukewarm water.
Wipe the inside of the waterproof case with a soft dry cloth. Do not wash it with water.
Be sure to perform the above maintenance each time you use the waterproof case. Do not use any type
of solvent such as alcohol, benzine or thinner for cleaning, as this might damage the surface finish of the
waterproof case.
When storing the waterproof case
To prevent deterioration of the waterproof packing, store the waterproof case in a cool, well-ventilated
location. Do not fasten the buckle.
Prevent dust from collecting on the waterproof packing.
Avoid storing the waterproof case in a cold, very hot or humid place, or together with naphthalene or
camphor, as these conditions might damage the waterproof case.
[17] How to use Getting Started Using Adhesive Mount
Using the adhesive mount
The adhesive mount is used for fixing the waterproof case or tripod adaptor to an item you intend to
use. The adhesive mount is a general term for the attachment buckle, flat adhesive mount, and curved
adhesive mount. Before attaching, insert the camera in the waterproof case or attach the tripod adaptor.
The adhesive mount can be attached to the FDR-X1000V without attaching the waterproof case or
the tripod adaptor.
The procedure for fixing the adhesive mount to the waterproof case is explained here.
1. Align the tripod screw hole in the bottom of the waterproof case with the tripod screw hole of the
attachment buckle, and fix firmly with the tripod screw.
Match the bottom of the camera and fix firmly with the tripod screw.
2. Attach the attachment buckle (with the waterproof case set in step 1) to the flat adhesive mount or
curved adhesive mount by sliding it until it clicks into place.