Filter
Top Products
3. Remove dust, moisture and oily substances completely from the surface where the adhesive mount is
to be attached.
4. Peel off the release paper on the back, and fix the adhesive mount in the desired location.
Adhesive power reaches its maximum strength 24 hours after the adhesive mount is attached to the
desired location.
To attach to or detach from the attachment buckle
Press and hold the circled part to unlock, then slide it in the opposite direction of step 2.
Note
The flat adhesive mount and curved adhesive mount cannot be used again once they are detached
from the location surface.
When detaching, peel off slowly. If peeled off forcibly, the surface on which the mount is fixed might
be damaged.
Before attaching, check the surface of the item to be used. If it is dirty, or dust, moisture or oily
substances are attached, adhesive strength may be impaired and the item could detach with slight
impact.
Use the appropriate adhesive mount (flat or curved) for the surface where the camera will be located.
If the mount is not suitable for the surface, it may detach by slight impact.
Thread a suitable leash through the leash attachment hole of the waterproof case, then attach the
leash to an item you intend to use with the camera.
Before use, confirm that the screw hole on the attachment buckle is not loose, and the flat or curved
adhesive mount is securely attached to the surface.
[18] How to use Shooting Shooting movies and still images
About the REC HOLD (lock) switch