Filter
Top Products
80
Thumbnail Search
Chapter 3 Recording and Playback
The “S1” and “S2” marks displayed on thumbnails
indicate frames where SHOT MARK1 and SHOT
MARK2 are set.
Thumbnails without one of these marks are frames
where REC START essence marks are set.
For details of chapter settings, see “Recording Shot
Marks” (page 65).
Deleting shot marks
You can delete a specified clip shot mark.
• Only SHOT MARK1 and SHOT MARK2 can be
deleted. REC START cannot be deleted.
• Shot mark deletion is only possible when the settings are
such that shot mark recording is possible.
• Essence marks cannot be deleted when the clip is locked
(page 81).
1
In the chapter screen, hold down the SHIFT button and
press the SEL/SET button down (CLIP MENU).
The CLIP menu appears (see page 95).
2
Select DELETE SHOT MARK.
3
Select the clip (SHOT MARK1 or SHOT MARK2).
By holding down the SHIFT button and turning the
MENU knob, you can select more than one chapter.
4
Press the SEL/SET button or MENU knob.
A confirmation message appears.
5
Select “OK” and then press the SEL/SET button or
MENU knob.
This deletes the specified shot mark.
Searching Using the Expand
Function
Using the expand function, you can divide the duration of
a selected clip on the thumbnail screen into 12 segments,
and display a new thumbnail screen showing the first
frame in each segment. This function allows rapid
searching of the scenes within a particular clip. The expand
function can be applied up to three times (12 divisions, 144
divisions, and 1728 divisions).
When FIND MODE on the ESSENCE MARK page of the
MAINTENANCE menu is set to CLIP, this function
operates in clip units. When FIND MODE is set to R.ST,
it operates in REC START essence mark units (the range
of a single recording operation).
The maximum number of blocks may be larger than 1728
when the recorded duration of the clip is short. In this case,
the frame interval of expanded thumbnails is fixed at 1
frame. This allows you to view expanded thumbnails at
equal intervals.
1
With the THUMBNAIL indicator and SUB CLIP
indicator off, press the THUMBNAIL button.
2
Use the SEL/SET button (four-way arrow key) or
MENU knob to select the desired clip.
3
Press the DISPLAY/EXPAND button on the right side
of the LCD monitor.
Thumbnails appear for twelve equal divisions of the
clip.
To change the expansion ratio
Each time you press the DISPLAY/EXPAND button
changes the ratio in the sequence ×12 → ×144 → ×1728.
To change the ratio in the reverse sequence, hold down the
SHIFT button and press the DISPLAY/EXPAND button.
Alternatively, press the RESET button on the right side of
the LCD monitor to return to the previous screen.
Clip List Playback
You can play back clips in their order in a clip list created
with the scene selection function (see Chapter 4).
Notes
Note
Displays the number
of clip divisions