Filter
Top Products
Configuring the Serial Port — Serial Setting Page / Configuring the Sensor I/O Port — Sensor I/O Setting Page
25
Configuring the Serial
Port
— Serial Setting Page
When you click Serial in the menu section, the Serial
Setting page appears.
Use this page to configure the RS485/232C serial port
on the rear panel of the camera.
Serial Port Selection
Select the protocol for the serial port from the drop-
down list. The selected protocol is automatically
displayed in Port Device Name.
Serial#1
Select this option when using RS-232C protocol.
Serial#2
Select this option when using RS-485 protocol.
Port Device Name
Displays the setting of Serial Port Selection.
Serial Transport
Select from the drop-down list, On to enable the RS485/
232C port, or Off to disable it.
Apply/Cancel/Help
See “Buttons common to every setting page” on page
14.
Configuring the Sensor
I/O Port
— Sensor I/O Setting Page
When you click Sensor I/O in the menu section, the
Sensor I/O Setting page appears.
Use this page to configure the Sensor I/O port on the rear
panel of the camera.
Upper Half of Sensor I/O Setting
Page
Activity Detection (AD)
Set up the activity detection that detects movement in
the image shot by the camera.
Available Alarm Events
Select Enable if you want to output an alarm when
movement is detected, or Disable if you do not want to
output an alarm.
Scheduling
Using the boxes below, you can set up to 6 schedules on
which the activity detection works.
Select Enable to enable all the schedules whose check
boxes you have selected, or Disable to disable them.
Scheduling 1 to Scheduling 6
For each schedule, type the time in hours and minutes
when the activity detection starts and ends, and select
the check box(es) of the working days of the week.
To enable each schedule you have set, select the check
box on the left of Scheduling. You can select multiple
schedules.
Note
A schedule across days (ex. 22:00 - 2:00) cannot be set.