Filter
Top Products
104
For details on the operation
1
page 80
• When cleaning the CCD, do not put the tip of a blower brush into the cavity
beyond the lens mount. You do not need to put the blower brush close to the
CCD.
6 Attach the lens and set the POWER switch to OFF.
• The camera starts beeping if the battery pack becomes low during cleaning. Stop the cleaning immediately
and set the POWER switch to OFF.
z To keep dust from entering the camera
While it is impossible to completely shut out dust, the following reminders should help lower the possibility.
• Choose a location with little dust to change the lens, and complete the operation quickly.
• Do not leave the camera without a lens or the body cap.
• When attaching the body cap, remove all the dust from the cap before placing it on the camera.
You can reset the main functions of the camera.
1 Select [Enter] in [Reset default].
The message “Reset default?” appears.
2 Select [Yes] with b on the controller, then press the center of the controller.
The main functions are reset.
• For details on the items to be reset, see “Reset default” (page 151).
Reset default