Filter
Top Products
Dubbing/Editing
94
Skip this step if you have selected [i.LINK]
in step 11 on p. 92.
bNote
• Run the tape for about 10 seconds before
pausing. The starting scenes may not get
recorded when you start recording from
the beginning of the tape.
3 Touch , then [ADJ TEST].
4 Touch [EXEC].
A picture (about 50 seconds long) with 5
[IN] and [OUT] indicators each for
adjusting synchronization is recorded.
[Completed.] appears when the recording is
finished.
5 Rewind the tape on your VCR, then
play back in slow mode.
5 opening numbers for each [IN] and
closing numbers for each [OUT] appear.
6 Take a note of the opening number
value of each [CUT-IN] and the closing
number value of each [CUT-OUT],
then calculate the average number
value for each [CUT-IN] and [CUT-
OUT].
7 Touch [CUT-IN].
8 Touch / to select the average
number value for [CUT-IN], then
touch .
The calculated start position for recording
is set.
9 Touch [CUT-OUT].
10Touch / to select the average
number value for [CUT-OUT], then
touch .
The calculated stop position for recording is
set.
11Touch [END] twice.