Filter
Top Products
109
Additional information
• Do not use any solvent (benzine, thinner,
static protection product, record cleaner,
etc.) to clean a disc.
Notes
• Do not remove the disc while reading or writing
data.
• Data may be damaged if:
– You remove the disc or shake the camera
while reading or writing data.
– You turn off your camera while reading or
writing data.
– You use the camera in a location subject to
the effects of static electricity or noise.
• Do not attach any material on the surface of a
disc. This causes a nonuniform rotating speed,
which may cause the camera to malfunction.
• You can write only on the label surface of a
disc. Write using only an oil-based felt-tip
marker and do not touch the ink until dry. Do
not heat the disc or use a sharp-pointed tool,
such as a ballpoint pen.
• Hold the disc at the edges while supporting the
center hole lightly. Do not touch the recordable
side (the reverse of the printed side) of a disc.
• When you carry or store a disc, put it in its case.
• Do not strike, bend, drop or rub the edge of a
disc.
• Do not store a disc in the following locations:
– In dusty or dirty places
– Exposed to direct sunlight
– Near heaters
– In damp places
• If you attempt to play back a disc on which no
images have been recorded using a CD-ROM
drive, the CD-ROM drive may malfunction or
the disc may be scratched.
On “InfoLITHIUM”
battery pack
What is the “InfoLITHIUM”
battery pack?
The “InfoLITHIUM” battery pack is a
lithium-ion battery pack that has functions
for communicating information related to
operating conditions between your camera
and the AC Adaptor.
The “InfoLITHIUM” battery pack
calculates the power consumption
according to the operating conditions of
your camera, and displays the remaining
battery time in minutes.
Charging the battery pack
We recommend charging the battery pack
in an ambient temperature of between 10°C
to 30°C (50°F to 86°F). You may not be
able to efficiently charge the battery pack
outside of this temperature range.