Toshiba 1600EP Film Camera User Manual


 
TOSHIBA
31
Display Screens (cont'd)
Data Display Screens
The 'Data Display Screens' sequentially displays all normal UPS operating data display screen as
the 'down' arrow key is pressed. The 'up' arrow can also be pressed at any time to back up to the
previous screen. These 'Data Display Screens' are accessed from the last 'UPS Start-up Screen' :
Notes:
1) If the key is pressed from any of the Data
Display Screens then the display will advance to
the Data Settings Screens. (See page 32)
2) Displays L-L input voltage (when an isolation
transformer is used, the unit senses input voltage
a +/- 3 volt difference between the display reading)
3) Displays L-N output voltages.
4) Displays the current as a % of maximum load
5) Displays the battery charge voltage as a % of
the rated nominal DC voltage of the batteries.
6) Date and Time setting
7) If the key is pressed from any one of the
Timer Start Data, Timer Stop Data, Weekly
Schedule, Special Operate, and Special Off time
screens then special 'Data Display Screens’ are
only to be changed by serial communication
interface.(See page 31).
Set
Monito
r
Shift
Select
See notes 1,2
See notes 1
See notes 1,3
See notes 1
See notes 1,4
See notes 1,5
See notes 1
See notes 1
See notes 1
See notes 1,6
See notes 1,7
See notes 1,7
See notes 1
See notes 1, 7
See notes 1,7
See notes 1,7
INPUT VOLTAGE
###V
INPUT FREQUENCY
##.#Hz
OUTPUT VOLTAGE
###V
OUTPUT FREQUENCY
##.#Hz
OUTPUT CURRENT
##%
BATTERY VOLTAGE
##%
BATT INSTALL DATE
11/04/1998
BATTERY LIFE
REMAIN 3.5YR
INTERNAL TEMP
## C
11/4/1998
10:45
TIMER START DATA
TO VIEW:SELECT
TIMER STOP DATA
TO VIEW: SELECT
CAL OPER MODE
DISABLE
WEEKLY SCHDULE
TO VIEW: SELECT
SPECIAL OPERATE
TO VIEW: SELECT
SPECIAL OPERATE
TO VIEW: SELECT