Filter
Top Products
TOSHIBA
34
Data Setting Screens
The following screens show the setting procedure for setting the data variables. They are accessed
from the main 'data setting screens' (see page 30) when the key is pressed:
Shift
Select
Returns to Data Setting
Screens (with new value
applied)
BUZZER VOLUME: 0
TO ACCEPT: SET
BUZZER VOLUME: 2
TO ACCEPT: SET
Loops through three
possibilities
Cont’d from Buzzer Data
Settings Screen page 32
Set
Monito
r
Shift
Select
+
BUZZER VOLUME:2
TO CHANGE: SELECT
BUZZER VOLUME: 0
TO CHAGNE:SELECT
2 = High
1 = Low
0 = Off
Default setting is 2 = High (loudest)
BUZZER VOLUME: 1
TO ACCEPT: SET
BUZZER VOLUME: 1
TO CHANGE: SELECT
Returns to Data Settings
Screens (with new value
applied)
Set
Monito
r
Shift
Select
+
Set
Monito
r
Shift
Select
+
The Keylock function allows the operator
to disable the RUN + STOP button
functions. When this function is set to
EN the unit will remain in the operating
mode it was in when enabled and will
not be able to be changed with the RUN
+ STOP buttons until this
function is disabled.
With this function set to DIS, the RUN +
STOP buttons function normally.
The default setting is DIS.
DEFAULT SETTINGS
PUSH: SELECT
DEFAULT SETTINGS
PUSH: SELECT
Loops through both
possibilities
Cont’d from Key Lock Data
Settings Screen page 32
KEY LOCK: DIS
TO CHANGE: SELECT
KEY LCOK:EN
TO CHANGE:SELECT
Set
Monito
r
Shift
Select
+
Set
Monito
r
Shift
Select
+
LCD SLEEP:30MIN
TO ACCEPT:SET
LCD SLEEP: 3MIN
TO ACCEPT: SET
Loops through both
possibilities
Cont’d from LCD Display
Time Data Settings Screen
page 32
LCD SLEEP: 3MIN
TO CHANGE: SELECT
LCD SLEEP:30MIN
TO CHANGE:SELECT
Displays the number of minutes (3 or 30)
of idle time before the LCD will go blank
(this is to prolong LCD life). The LCD will
be active again once a display button is
pressed. Default setting is 3 min.
Returns to Data Setting
Screens (with new value
applied)
Set
Monito
r
Shift
Select
+
Set
Monito
r
Shift
Select
+
AUTO RUN: NO
TO ACCEPT:SET
AUTO RUN: YES
TO ACCEPT:SET
Loops through both
possibilities
Cont’d from Auto Run Data
Settings Screen page 32
AUTO RUN: YES
TO CHANGE: SELECT
AUTO RUN: NO
TO CHANGE:SELECT
If set to YES, the unit will automatically
start up in the UPS mode (on line) when
input voltage is applied, regardless of
what mode it was in when shut down.
Default setting is NO.
Returns to Data Setting
Screens (with new value
applied)
Set
Monito
r
Shift
Select
+
Set
Monito
r
Shift
Select
+