Toshiba 1600EP Film Camera User Manual


 
TOSHIBA
38
Display Screens (cont'd)
Data Setting Screen
The following screens show the setting procedure for setting the data variables. They are accessed
from the main 'data setting screens' (see page 30) when the key is pressed:
Shift
Select
TO BEGIN:SET
BATTERY TEST
INHIBIT
Cont’d from Bat. Test interval
Data Setting Screen Page 32
Set
Monito
r
Shift
Select
+
BATTERY TEST
###%
This parameter has no options to set. A
battery test will be performed once the
SHIFT + SET button is pressed.
If the BAT TEST INHIBIT message is
displayed, it indicated that a battery test
has been performed recently. The UPS
will not allow frequent battery tests to
insure that the batteries remain in a fully
charged state.
Executes battery
test and returns
to Data Settings
Screens
OR
This parameter allows the user to offset
the output voltage (while the unit is
running on-line), by 1% increments
between -5% to +5%.
Default value is +0
VOLTAGE ADJ: +0
TO ACCEPT: SET
VOLTAGE ADJ: +5
TO ACCEPT: SET
Loops through three
possibilities
Cont’d from Voltage Adj
Data Settings Screen
page 32
Set
Monito
r
Shift
Select
+
VOLTAGE ADJ: +5
TO CHANGE: SELECT
VOLTAGE ADJ: +0
TO CHAGNE:SELECT
VOLTAGE ADJ: -5
TO ACCEPT: SET
VOLTAGE ADJ: -5
TO CHANGE: SELECT
Returns to Data Settings
Screens (with new value
applied)
Set
Monito
r
Shift
Select
+
Set
Monito
r
Shift
Select
+
Cont’d from Clear Timer
Data Setting Screen Page 32
CLEAR TIMER SET
TO ACCEPT: SET
Set
Monito
r
Shift
Select
+
CLEAR TIMER SET
TO CHANGE:SELECT
This parameter has no options to set.
Pressing the SHIFT + SET button while
this message is displayed will cancel
timer setting.
Executes battery test
and returns to Data
Settings Screens
Cont’d from Default Data
Data Setting Screen Page 32
DEFAULT SETTINGS
TO ACCEPT: SET
Set
Monito
r
Shift
Select
+
DEFAULT SETTINGS
TO CHANGE:SELECT
This parameter has no options to set.
Pressing the select button while this
message is displayed will reset all
parameters to their default values.
Executes battery test
and returns to Data
Settings Screens