Filter
Top Products
5
This product is a 3CCD color camera with digital video output.
CAUTIONS ON USE AND INSTALLATION1.
•Handlingtheunit.
Do not drop, jolt, or vibrate, as this may result in
damage to the unit and may cause problems.
Treat the camera cables carefully to prevent cable
problems, such as breaks in the cable and loose
connections.
•Installthecamerainalocationfreefromnoise.
If the camera or the cables are located near power
utility lines or a TV, etc. undesirable noise may
appear on the screen. In such a case, try to change
the location of the camera or the cable wiring. Con-
sult with a service personnel, if the noise still appears
after changing the location or the cable wiring.
•Operatingambienttemperatureandhumidity.
Do not use the camera in places where temperature
and humidity exceed the specifications. Picture
quality will deteriorate and internal parts may be
damaged.
Be particularly careful when using in places exposed
to direct sunlight. When shooting in hot environ-
ments, depending on the conditions of the object and
the camera (for example when the gain is increased),
noise in the form of vertical strips or white dots may
occur. This is not a malfunction.
•Whennotusingthecameraforextendedperiods
of time.
Switch the control unit off and disconnect the power
supply.
•Avoidusingorstoringthecamerainthefollow-
ing places:
Places filled with highly flammable and corrosive gas.
Places near gasoline, benzene, or paint thinner.
Places subject to strong vibration.
Places containing chemicals (such as pesticides),
rubber or vinyl products for extended periods of time.
•Donotshootintenselight.
If there is an intense light at a location on the screen
such as a spot light, a blooming and smearing may
occur. When intense light enters, vertical stripes
may appear on the screen. This is not a malfunction.
Ghosts may occur when there is an intense light near
the object. In this case, change the shooting angle.
•Moire
A moire pattern is an interference pattern generated
when two repetitive line patterns overlap. This is not
a malfunction. Eliminating the repetitive line patterns,
or aligning the two patterns, will eliminate the moire.
•Handlingoftheprotectioncap.
Keep the protection cap away from children as they
may pose a choking hazard. The protection cap
protects the image sensing plane when the lens is
removed from the camera head, do not discard.
•Whencleaningthecamera.
Unplug the power source before cleaning. Clean with
a soft dry cloth only. Do not use chemicals or chemi-
cally treated cloths. Chemicals may damage coatings
and printed letters. When cleaning the lens, use lens
cleaning paper.
COMPONENTS2.
(1) Camera Control Unit ...................................................................................................................... 1
(2) Accessories
(a) Instruction manual .................................................................................................................. 1
(b) EMI core ................................................................................................................................. 1
7. 5 Partial Read ............................................32
( 1 ) Partial Scanning OFF
(All pixels scanning) ................................32
( 2 ) Partial Scanning ON ...............................32
( 3 ) When Partial Scanning Mode is ON .......33
7. 6 External Sync ..........................................34
( 1 ) External sync signal polarity ...................34
( 2 ) External sync frequency range ...............34
( 3 ) Using the unit with external sync signal ..34
(3. 1) H (horizontal) phase adjustment ..34
8. INPUT OUTPUT SIGNAL SPECIFICATIONS 35
9. CCDOUTPUTWAVEFORMTIMINGCHART 36
10.BEFOREMAKINGASERVICECALL ........... 37
11. SPECIFICATIONS ..........................................37
12. EXTERNAL APPEARANCE DIAGRAM.........38
120730c1_IK_TF7P2_EN.indd 5 12.7.30 1:18:59 PM