Filter
Top Products
TV-IP612P/WN (Wireless N) Pan/Tilt/Zoom Internet Camera
10
Connect Ethernet Cable
To connect the camera to your network, connect a Category 5 or better
Ethernet cable to the network cable connector located on the camera’s
left side panel, and then attach it to the network. The Ethernet port will
automatically detect and adjust to the speed (10 or 100 Mbps) and
polarity (MDI-II or MDI-X) of the connection.
Connect Power and Power On Camera
To provide power to the camera, connect the AC power adapter to the
DC power input connector, also located on the camera’s left side panel,
and then plug it to the electrical outlet. As with any electrical device,
make sure the power source and camera are located in an area where it
is not going to get wet or present an electrical hazard.
CAUTION: The Camera must be used with the power
adapter included with the device.