Filter
Top Products
User’s Manual >>
EN-21
Charging the Battery
Using the optional AC power adapter may charge the battery or operate the
ViviCam 8300s as power supply. Make sure that the power of the ViviCam
8300s is off and then insert the battery before starting.
1. Insert one end of the AC power adapter into
the DC IN 5V terminal of the ViviCam 8300s.
2. Insert the other end of the AC power
adapter into a wall outlet.
The status LED lights red when
charging is started and goes out when
charging is completed.
It is recommended to fully discharge the
battery before recharging.
Charging time varies according to the
ambient temperature and the status of battery.
This ViviCam 8300s must be used with specified AC power adapter.
Damage caused by the use of an incorrect adapter is not covered
underthe warranty.
Always make sure that the ViviCam 8300s is off before removing the battery.
The battery may feel warm after it has been charged or immediately
after being used. This is normal and not a malfunction.
When using the ViviCam 8300s in cold conditions, keep the ViviCam
8300s and battery warm by storing it in a warm place such as an
interior pocket between shots.
If you open the battery cover without removing the battery, the
battery power will not be disconnected.
If you remove the battery, you have to insert the battery within two
hours in order to make sure that the date and time will not be reset.