Filter
Top Products
Digital Camera >>
EN-22
Using an AC Power Adapter (Optional Accessory)
Using an AC power adapter prevents the ViviCam 8300s from automatically powered
off while transferring files to your computer. Perform the steps in the preceding
section “Charging the Battery”.
Make sure to use only the AC power adapter specified for the
ViviCam 8300s. Damage caused by the use of an incorrect adapter
is not covered under the warranty.
Inserting and Removing an SD Card (Optional Accessory)
The ViviCam 8300s comes with approx. 32 MB of internal memory (25.9 MB for
image storage), allowing you to store captured still images or movie clips in the
ViviCam 8300s. However, you can also expand the memory capacity by using an
optional SD card so that you can store more files.
Inserting an SD card
1. Open the battery/SD card cover.
2. Insert the SD card in the correct orientation shown.
Hold the SD card with its front side
(printed arrow) facing the rear side of
the
ViviCam 8300s, and then insert the
card as far as it can go. There will be a
distinct click as the card seats fully into
the card slot.
3. Close the battery/SD card cover.
Removing an SD card
Open the battery/SD card cover, press lightly on the edge of the SD card and it will eject.
To prevent valuable data from being accidentally erased from an SD
card you can slide the write-protected tab (on the side of the SD card) to “LOCK”.
However, to save, edit or erase data on an SD card, you must unlock the card.