Filter
Top Products
SPEEDDOME ULTRA VII GLOSSARY
Alarm Actions
The assigned responses for the dome when inputs change from normal to abnormal
states. The dome may run a Preset, Pattern, or have no assigned action for each of the
four dome inputs. The dome may also send alarm states to the host controller for
processing. See also Input and Normal Input State.
Apple Peel
Pattern
The default pattern of the SpeedDome Ultra VII. This pattern consists of three complete
revolutions starting at the ceiling line and tilting down 30° each revolution.
Areas
Programmed start and end points of the dome's field of view around its pan axis. Each
area is a part of a circular viewing area that extends around the dome. The areas can be
different sizes. Up to 16 areas can be programmed for the dome.
Automatic “Flip”
feature
Allows the dome to automatically turn 180-degrees when the camera tilts to its lower
limit and stays in that position for a brief delay. When the dome flips (rotates), the
camera starts moving upward as long as the tilt control is kept in the down position.
Once the control is released, the tilt control returns to its normal operational mode. The
flip feature is useful when you need to track someone who walks directly beneath the
dome and continues on the other side. This is also referred to as “proportional flip.”
Automatic Gain
Control (AGC)
Allows for the amplification of the video signal in scenes with minimal ambient light.
Many low-light scenes result in picture noise. As gain is increased, the picture noise is
also amplified. When AGC is enabled, the value of the gain setting is based on feedback
from the camera. When AGC is disabled, the camera uses the value set for the manual
gain setting. The trade-off between picture level and noise may be adjusted when AGC
is disabled. See also Open Shutter.
Configuration
Utility
The text overlay menu system used for setting dome features. The utility is accessed
using a keystroke combination. The utility provides settings for camera functions,
zoom, alarms, text display, and password protection.
Direction
Indicators
Provides for the display of the camera dome's pointing direction based on the North
setting. This information appears on the top line of the monitor when the setting is
enabled. In addition, the tilt setting appears on the left side of the monitor. By default,
North is set to 0° Pan/Tilt. This setting may be changed using the Set North Position
setting. See also North Position.
Dome
Information
A Dome Configuration Menu choice that provides essential information about the
SpeedDome Ultra VI camera dome if service is required. When you view this screen,
you can determine the dome type, mnemonic, software version, serial number, and
manufacture date. The information on this screen cannot be modified. See Dome
Statistics.
Dome Statistics
A feature that identifies the operating statistics for the dome. The information displayed
represents either runtime in seconds or number of occurrences. See Dome Information.
Dome Status
Information
Relates to zoom, focus, and iris settings. You may choose to have this information
displayed on the monitor when any of these settings change. If display of status
information is enabled, it appears in the upper left corner of the monitor.
Flip
To automatically rotate the dome 180° from its current pointing position.
See Automatic “Flip” feature.