Filter
Top Products
Supported Controllers and Matrix Switching Systems
This section provides information about the SensorNet and RS-422 controllers and matrix switchers that are
compatible with SpeedDome Ultra VII. Refer to the controller information for details concerning specific functions
supported.
Note: This list of controllers is complete as of the time of publication. Other controllers may be
supported. Contact your Sales Representative for current information.
Controller/Switcher Page Number Controller/Switcher Page Number
• VM8
A–3
• AD1650
A–4
• VM16/ADTT16
A–3
• AD168
A–4
• VM16E/ADTT16E
A–3
• AD2050
A–5
• VM32/AD32
A–4
• MegaPower LT
A–5
• VM96
A–4
• MegaPower 48
A–5
• AD2150/AD2350
A–4
• MegaPower 1024
A–5
VM8
Supported Protocol SensorNet
Maximum Presets 0
Maximum Patterns
(1)
1
Quick Set Menu Not supported
Address Range 1-8
Notes:
(1) Apple Peel only. Programmable patterns are not
available.
VM16/ADTT16 (White Touch Tracker)
Supported Protocols SensorNet
RS-422
(1)
Maximum Presets 96 – SensorNet
4 – RS-422
Maximum Patterns
(2)
3
Quick Set Menu Not supported
Address Range 1-16
Notes:
(1) Requires RCSN422 code converter.
(2) Patterns are limited by time and the number of
available dome commands. Total time for each
pattern cannot exceed 6 minutes 50 seconds.
Total dome commands used in the all patterns
cannot exceed 99.
VM16E/ADTT16E (Black Touch Tracker)
Supported Protocols SensorNet
RS-422
(1)
Maximum Presets 96 – SensorNet
4 – RS-422
Maximum Patterns
(2)
3
Quick Set Menu
Yes
(3)
Address Range 1-16 or
1-64
(3)
Notes:
(1) Requires RCSN422 code converter.
(2) Patterns are limited by time and the number of
available dome commands. Total time for each
pattern cannot exceed 6 minutes 50 seconds.
Total dome commands used in all patterns cannot
exceed 99.
(3) Requires firmware version 0701-2833-0103
(EEPROM) / 0701-2834-0201 (Flash PROM) or
newer.
SensorNet and RS-422 Protocols Command Summary A–3