Filter
Top Products
153153
• Hang the hook of the measurement device ➪ photo
on the film core which is to be measured.
• Attach the open magazine to the camera.
Do not place your hand in the running
magazine!
• To set the take-up shaft, run the camera at 24 fps. The
tension measurement device should be showing ring “5”.
• If the tension measurement device is not showing “5”,
stop the camera.
• Switch off the camera’s main switch and disconnect the
camera from the power supply.
• Place the special key ➪ photo in the holes of the
friction adjustment and turn in steps. The adjustment
must lock in at each step. When setting friction, the
corresponding winding shaft must be held firmly.
• Turn clockwise to increase friction, counter-clockwise to
decrease friction.
• Connect the camera to the power supply and switch on.
• Run the camera at 24 fps.
• Check the tension.
Note: Repeat this procedure until ring “5” is shown.
• After setting the friction, replace the tensioning plate.
• Fasten the plate with the three screws.
core adapter measurement device
hook
roller arm
special key screws
transparent tensioning plate
Maintenance