Filter
Top Products
32
32
• By again turning the drive gear counter-clockwise, trans-
port the film inside the magazine.
• Flip up the hinged locking clip on the take-up shaft
➪ photo.
• Place an empty film core on the take-up shaft. Ensure
that the take-up shaft catch engages the slot on the
plastic core.
• Press down the hinged locking clip on the take-up shaft.
• Insert the film into the slit of the film core ➪ photo.
• Wind the film on several revolutions until it is certain
that the film is firmly seated on the film core.
• Check that the film is being taken up perpendicular to
the shaft ➪ photo.
• Close the magazine cover by inserting the two latches
into the slits of the magazine housing and then closing
the cover. The roller arm will be automatically
unlocked.
• To lock the cover, turn the locking grip clockwise and
flip it back into the recess.
The safety catch locks automatically.
film core
slit
hinged locking clip
loaded magazine
Magazines