Filter
Top Products
3434
6.2 Removing Exposed Film
The following steps should be carried out in a darkroom
or a changing bag!
• Check if the entire film has been wound into the interior
of the magazine. If not, transport the film into the
magazine by turning the drive gear counter-clockwise.
• To open the cover, depress the safety catch and flip the
locking grip upwards. Then turn the grip counter-clock-wise.
• Lift up the cover and remove it by pulling it to the left.
• Swing the roller arm ➪ photo away from the winding
shaft until it locks in place.
• Flip up the hinged locking clip on the take-up shaft.
• Pull the film roll upwards and off.
Note: When pulling the film roll off the shaft, grip it
from underneath as far as possible to prevent
the middle of the film roll from sagging down.
The film should under no circumstances be
pulled tight. This could cause scratches and
static charging.
roller arm
Magazines