Axis Communications 2100 Security Camera User Manual


 
AXIS 2100 User’s Guide Configuring Your Camera
25
Reinstating the Factory Default Settings
In certain circumstances, it may be necessary to reinstate the Factory Default settings for
your AXIS 2100. This is performed by clicking the Support link in the Administration
Tools and then selecting Restart/Reset, or by pressing the Control Button. Follow the
instructions below to reinstate the product factory default settings using the Control
button:
1. Switch off the AXIS 2100 by disconnecting the power cable.
2. Press and keep the Control Button pressed, and then reconnect the power supply cable.
3. Keep the Control Button pressed until the Status Indicator displays yellow (note that
this may take up to 15 seconds), then release the button. When the Status Indicator
displays green (which can take up to 1 minute) the AXIS 2100 will then have been reset
to the original factory default settings.
Notes: •Reinstating the original default settings will cause all parameters (including the IP address) to
be reset.
•Refer to Installing Your Camera on a Network, on page 11, for information on how to set the
camera’s IP address.