Filter
Top Products
EN | 88 Installation and Operating Manual | VIP X1
Configuration using a Web browser Bosch Security Systems | 2006-12 | V2.5
SNMP traps:
You can choose, which traps are sent.
– Click Select. A dialog box appears.
– Click the check boxes of the appropriate traps.
– Click OK to close the window and send all of the checked traps.
Authentication:
If a RADIUS server controls access rights in the network, you must activate
authentication here. Otherwise there will be no communication with the device.
The respective data must also be stored in the RADIUS server.
For configuration you must connect the VIP X1 directly to a computer using a
crossed network cable since communication via the network is only possible
when the parameters Identity and Password have been set and authentication
was successful.
Identity:
Enter the user name that the RADIUS server uses for identification of the
VIP X1.
Password:
Enter the password that is stored in the RADIUS server.
Automatic IP assignment:
If the network has a DHCP server for dynamic IP allocation, you can activate the
acceptance of the automatically assigned IP address here. In this case, the IP
entered above on this page will be overwritten the next time the unit boots
(restart).
Caution
The DHCP server must support the allocation of static IP addresses based
on MAC addresses and must be configured accordingly, so that the unit
receives the same IP address after each restart. If not, the unit may no
longer be accessible via its IP address, or controlling systems, such as
VIDOS or Bosch Video Management System loose the allocations.