Filter
Top Products
42
E
Using the Full
Range of Features
Using the ND Filter
ND
FILTER
On bright days or when recording very bright scenes, despite the iris being at its smallest aperture,
blurring of the image may occur. If this happens, using the ND filter should remove this problem.
Turn the ND filter on by pressing the ND FILTER button.
• ND is shown continuously in the display while the ND filter is turned on.
– ND ON flashes in the display to advise you to switch the ND filter on. (However it doesn’t appear in
the Manual mode or during exposure lock.)
– ND OFF with the “OFF” flashing warns you that the ND filter is no longer suitable for the current
conditions. If this warning appears, turn the ND filter off by pressing the ND FILTER button again.
Notes:
• You cannot turn the ND filter on/off during exposure lock or while the PHOTO button is pressed
halfway down.
• The camcorder remembers your selection if you turn the standby lever to LOCK. However, it resets to
the off setting if you slide the POWER switch to OFF.