Filter
Top Products
86
E
Additional
Information
Setting the Audio Mix
AUDIO
MONITOR
MIX
BALANCE
ST-1
ST-2
POWER
OFF
VCR
CAMERA
When you play back a tape that was recorded in 12-bit mode, you can set the audio output to play:
stereo 1 (the original sound), stereo 2 (any new sound, dubbed to the tape after recording), or mix the
balance between the two.
• Audio from the 16-bit mode only contains stereo 1 sound and so you cannot/do not need to select the
audio mix. The same is true for the 12-bit stereo 1 mode, unless new sound has been added post-
recording.
• You can choose the output using the wireless controller only.
1. Set the camera to VCR mode.
2. Choose the output.
• Press AUDIO MONITOR on the wireless controller.
• Four settings appear as you push the button:
– STEREO1 for just stereo 1.
– STEREO2 for just stereo 2.
– MIX/FIXED for an equal mix of stereo 1 and 2.
– MIX/VARI. (mix variable) for when you want to mix the balance between stereo 1 and 2.
• To simply choose STEREO1, STEREO2 or MIX/FIXED, make sure your choice appears on the
display.
• If you choose MIX/VARI., you can go on to mix the balance.
• Use the ST-1/ST-2 keys to mix the balance. A bar showing the mix appears on the screen for four
seconds.
Notes:
• When you have chosen the output, STEREO1, STEREO2, MIX/FIXED or MIX/VARI. is shown in the
top left of the display for a few seconds.
• If you turn the power off the output is set to STEREO1, however, if you select MIX/VARI. again with
the wireless controller, your previously mixed balance will appear.