Filter
Top Products
74
E
Editing
Simple Editing to a VCR
1. Find a point on your recorded cassette slightly before the section you want to copy.
2. Start to play it back while you monitor the picture on the TV.
3. Start recording on the VCR as soon as the section you want to copy appears on the
screen.
4. Pause the VCR at the end of the section you want to copy, then stop playback on the
camera.
5. Repeat steps 1 to 4 until your edited recording is complete.
Note:
• The quality of the edited tape will be slightly lower than that of the original.
If you cannot find the appropriate remote control setting for the camcorder to control your VCR, you still
can edit a tape to the VCR as follows.
1. Connect the camera to the VCR.
• See “Connections for Playback on a TV Screen” on p. 30.
2. Prepare the TV and VCR.
• Turn on the TV and set it to the video channel, or set the TV/VIDEO selector to VIDEO.
• Turn on the VCR, and set its input selector to LINE. Load a blank cassette, and put the VCR in
record pause mode.
• See your TV and VCR instruction manuals for details.
3. Turn the camera’s POWER switch to VCR, and load your recorded cassette.
The m REMOTE terminal allows you to connect the camera to
equipment. Some buttons on editing equipment may operate
differently from those on the camera.
Preparations
Basic editing
m REMOTE terminal
DV
IN/OUT
A/V
IN/
OUT
Notes:
• m (LANC) is a trademark. It stands for Local Application Control Bus System.
• We cannot guarantee the results when connecting to equipment not bearing the LANC m symbol.