Filter
Top Products
379
Troubleshooting Guide
[Eye-Fi settings] will appear only when an Eye-Fi card is inserted in
the camera. If the Eye-Fi card has a write-protect switch set to the
LOCK position, you will not be able to check the card’s connection
status or disable Eye-Fi transmission (p.352).
It is the highlight alert (p.310). Overexposed areas with clipped
highlight will blink.
If the image is protected, it cannot be erased (p.302).
Movies edited with a computer cannot be played back with the camera.
If you operate the camera’s dials or lens during movie shooting, the
operation noise will also be recorded. Using an external microphone
(commercially available) is recommended (p.251).
During autoexposure movie shooting, if there is a drastic change in the
exposure level, the recording will stop momentarily until the brightness
stabilizes. In such cases, shoot in <a> mode (p.225).
[Eye-Fi settings] does not appear.
Playback Problems
Part of the image blinks in black.
The image cannot be erased.
The movie cannot be played back.
Camera operation noise can be heard when the movie is
played back.
The movie has still moments.