Filter
Top Products
110
To start with, check if the access point supports Wi-Fi Protected Setup
(WPS) that allows easy connection between Wi-Fi devices.
If you do not know if the access point you use is WPS-compatible, refer
to the access point instruction manual or other documentation.
When WPS is supported
The following two connection methods are available. Connection
can be established easier with WPS (PBC mode). However, both
provide high security settings.
• Connection via WPS (PBC mode): Perform the operations
described on page 111.
• Connection via WPS (PIN mode): Perform the operations
described on page 114.
When WPS is not supported
• Manual connection by searching networks: Perform the operations
described on page 117.
Checking the Type of Access Point
If stealth functions of the access point are enabled, connection may
be disabled. Deactivate stealth functions.
When connecting to a network that has a network administrator, ask the
administrator about the detailed setting procedures.
If the network you use filters by MAC address, register the MAC address of
the camera at the access point. The MAC address can be checked on the
[General sett.] screen (p.138).