Filter
Top Products
79
Manual Connection by Searching Networks
4
Select [Find network].
Press the <W> <X> keys to select
[Find network], then press <0>.
Select [OK] and press <0> to go to
the next screen.
5
Select an access point.
Press <0> to enable the selection of
an access point.
Press the <W> <X> keys to select an
access point, then press <0>.
Select [OK] and press <0> to go to
the next screen (p.80).
(1) First few characters of the SSID
(2) An icon is displayed if the access point is encrypted
(3) Channel used
Access Point Encryption
This camera supports the following options for [Authentication] and
[Encryption settings]. Therefore, the encryption used by the access
point must be one of the following.
[Authentication]: Open system, Shared key, or WPA/WPA2-PSK
[Encryption settings]: WEP, TKIP, or AES
[Enter connection] and [Search again]
To configure settings for the access point manually, select [Enter
connection] and press <0>. Enter the SSID using the virtual
keyboard and then configure settings following the instructions
displayed.
To search for access points again, select [Search again] and press
<0>.
(1) (2) (3)