Filter
Top Products
148
Responding to Error Messages
Did you hold down the access point’s WPS (Wi-Fi Protected
Setup) button for the specified period of time?
X Hold down the WPS button for the period of time instructed by the
access point’s instruction manual.
Are you trying to establish a connection near the access point?
X Try establishing the connection when both devices are within reach
of each other.
Connection is in progress by other access points in Pushbutton
Connection mode (PBC mode) of Wi-Fi Protected Setup (WPS).
X Wait a while before trying to establish the connection, or try to
establish a connection in PIN code connection mode (PIN mode)
(p.74, 114).
A problem other than error number 11 to 69 occurred.
X Turn off and on the camera’s power.
Has the procedure to establish a connection between
cameras been performed on the other camera as well?
X Perform the procedure to establish a connection between cameras
on the other camera as well.
X
When reconnecting cameras for which connection settings have been
registered, perform the reconnection procedure on both cameras.
Is connection being attempted by multiple cameras?
X The camera can be connected to only one camera at a time.
Confirm that no other camera is attempting to establish a
connection nearby and retry connection.
68: Cannot connect to wireless LAN terminal. Retry from
the beginning.
69: Multiple wireless LAN terminals have been found.
Cannot connect. Retry from the beginning.
91: Other error
101: Could not establish connection