Filter
Top Products
Basic Printing
10
3 Load the paper.
4 Pull out the Paper Output Tray.
Pull out completely as shown.
Note
• Do not stack more than 50 sheets in the Paper Output Tray.
• Do not touch the printed surface until the ink dries. For specific
drying times, refer to the instructions packaged with your media.
Note
• You can also select the paper source from the printer driver. For
details, refer to "U
Using the Auto Sheet Feeder and the Front Sheet
Feeder" in the
User’s Guide
.
• When you load the media in the Front Sheet Feeder, ensure that you
are printing on the correct side of it as shown below.
• To Print with Duplex Printing
After printing one side, the printed paper can be fed from the Auto
Sheet Feeder.
Load the paper in the Auto Sheet Feeder to print on the other side,
according to the message shown on the screen.
(2) Align the paper stack against the
right side of the Front Sheet Feeder.
(3) Pinch the Paper Guide and slide it
against the each side of the paper
stack.
(1) Insert the paper into the Front
Sheet Feeder with the print side
facing down. Load the paper so that
the leading edge of paper is set
firmly against the rear end.
QSG_Basic.fm Page 10 Wednesday, May 19, 2004 5:30 PM