Filter
Top Products
11Before Printing
z Loading Paper in the Auto Sheet Feeder
1 Flatten the four corners of the paper before loading it.
2 Prepare to load paper.
(1) Open the Sheet Feeder Cover and pull out the
Paper Support.
(2) Open the Front Feeder.
(3) Extend the Output Paper Support.
(4) Adjust the position of the Paper Thickness
Lever.
Set it to the right when printing on envelopes or
T-shirt transfers, and left when printing on any
other type of paper. See “Paper Handling” on
page 4.
3 Load the paper.
(1) Load the paper in the Auto Sheet Feeder with
the print side facing UP.
(2) Align the paper stack against the Cover Guide
on the right side of the Paper Support.
(3) Pinch the Paper Guide and slide it against the
left side of the paper stack.
Note
z Align the edges of paper neatly before loading. Loading paper without aligning the edges may
cause paper jams.
z If paper is curled, hold the opposing curled corners and gently bend them in the opposite
direction until the paper becomes completely flat. See “Paper is curled.” on page 58.
z To avoid curling, handle paper as follows.
– Put unused paper back into the package and keep them on a level surface.
– Take out only the necessary number of sheets from the package, just before printing.
Note
Make sure that the Cover Guide is set upright when
you load paper in the Auto Sheet Feeder.
(1)
(4)
(2)(3)
(A)
(1)
(2)
(3)
Do not load higher than the Load Limit
Mark (A).