Filter
Top Products
Getting Started Connections Setup Information Troubleshooting
Specifications
Other Operations and
Functions
1
Turn off the power using the <ON/STANDBY>
button.
2
While pressing the <SETUP> and <RETURN> buttons,
press the <ON/STANDBY> button for at least one
second.
3
Once the display starts ashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
Backup Memory
The various settings are backed up for about 1 week, even if
the power is turned off or the power cord is disconnected.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if
operations cannot be performed.
When the microprocessor is reset, all the settings are reset
to their default values.
1
Hold down the [ALL OFF] button on the remote control
unit and press the [ADVANCED SETUP] button with
the tip of a pen.
The Transmission Indicator light blinks four times.
2
Hold down the [ALL ON] button on the remote control
unit and press the [ADVANCED SETUP] button with
the tip of a pen.
The Transmission Indicator (DVP) light blinks four times.
Resetting the remote control unit
Resetting in case of wrong operation of the remote control,
or when operation is impossible.
Personal Memory Plus Function
This function sets the settings (input mode, etc.) last selected for
the individual input sources.
When you switch to an input source, the settings are automatically
set to the ones that were set the last time that input source was
used.
Last Function Memory
This stores the settings as they were directly before the
standby mode was set.
When the power is turned back on, the settings are restored
to as they were directly before the standby mode was set.
NOTE
•
To perform web control, you must connect a web control device
such as a PC to the same network as the DVP-602CI.
•
With web control, some network settings, etc., cannot be set.
•
When updating firmware, settings made by the web controller may
be reset.
G
Example:2
H
Setup Menu Screen
G
Example:3
H
PDA menu screen
NOTE
You cannot change setup menu operations on the PDA menu
screen.
Select when
performing
main control
Enter figures or click <
> to make the setting,
and then click “Set”.
Playback
Click to
determine a
setting
After entering
characters, click “Set”
to set, or click “Def” to
return to initial setting
Click the menu from which you want to make
settings
The display on the right becomes each setting screen
Click “SAVE” when you want to save settings,
and click “LOAD” when you want to call settings
Becomes each operation screen
DVP602CI_ENG_6th.indd 26 2008/03/26 16:37:45