Filter
Top Products
6
Connections
Network Cable Connector
The Internet Camera’s rear panel features an RJ-45 connector for connections to 10Base-
T Ethernet cabling or 100Base-TX Fast Ethernet cabling (which should be Category 5
twisted-pair cable). The port supports the NWay protocol, allowing the Internet Camera
to automatically detect or negotiate the transmission speed of the network.
DC Power Connector
The DC power input connector is located on the Internet Camera’s rear panel and is
labeled DC 5V with a single jack socket to supply power to the Internet Camera.
Reset Button
Reset will be initiated when the reset button is pressed once and Power LED begins to
flash.
Factory Reset will be initiated when the reset button is pressed continuously for three
seconds or when Power LED begins to light up. Release the reset button and the Power
LED will begin to flash indicating that the Internet Camera’s settings are reverting back
to the factory settings. When factory reset is completed the Internet Camera will be set
to default on channel 11 and EES-ID is set as “NULL String.” (This default setting will let
the Internet Camera connect to ANY access point on the infrastructure network.) The IP
address will also return to the default setting of 192.168.0.20.
Antenna Connectors
(DCS-1000W only)
Ethernet Cable
Connector
Reset Button
Slide Switch
(DCS-1000W only)
DC Power Connector
I/O Connector