Filter
Top Products
`
IC-7000 CAM User’s Guide
P
P
a
a
n
n
/
/
T
T
i
i
l
l
t
t
I
I
P
P
S
S
u
u
r
r
v
v
e
e
i
i
l
l
l
l
a
a
n
n
c
c
e
e
C
C
a
a
m
m
e
e
r
r
a
a
IC-7000 USER’S GUIDE PAGE 21/62 Rev. PV1.0
and port settings of camera to make proper configuration.
4. To view the image of IP-CAM from remote computer: Launch IP browser and type
the public IP address of the residential router and the port number of IP-CAM, e.g.,
http:// 211.78.174.01:1025
Scenario 4
The way to access Internet ADSL or Cable Modem
Public IP address required? Yes, one public address is required
DHCP server required? No
Network Setup for IP -CAM LAN Enable / Manually
This scenario is best for: Users with one public physical IP address and
one IP-CAM.
1. Connect the red test network cable to the RJ-45 Ethernet jack located on the rear of
IP-CAM. The other end is connected to the network card of computer.
2. Refer to 2.4-1 STATIC – IP Address Settings to input IP address properly.
3. Set up the IP-CAM with a public IP address.
4. To view the image of IP-CAM from remote computer: Launch IP browser and type
the public IP address of the residential router and the port number of IP-CAM, e.g.,
http:// 211.78.174.01:1025