Filter
Top Products
Using PhotoPC with Your Macintosh
3-3
A
3
5
Locate the modem port or printer port on the back of your
Macintosh, marked with these icons:
6
With the arrow on the cable facing up, line up the cable connector
with the port on your Macintosh. Then insert the connector.
7
Turn on the camera and your Macintosh. A frame appears around
the picture counter on the camera’s control panel.
NOTE
When the camera is connected to your Macintosh, you can’t use any of
the control buttons or the shutter button on the camera. You can operate
the camera only through your Macintosh.
The camera’s auto shut-off feature remains in effect when the camera is
connected to your Macintosh, but shut-off takes place after 5 minutes of
inactivity instead of 60 seconds. To turn the camera back on, you can
slide the power switch off and on again, or you can use any of the
software camera controls on your Macintosh, as explained in Chapter 5.
PhotoPC Mac cable or
Mac adapter cable
printer port on
Macintosh
modem port on
Macintosh
AUTO
TITLE
Line indicates that the camera is
connected to your Macintosh.