Filter
Top Products
CAMERA SETUP
11
English
BATTERIES AND MEMORY CARD INSTALLATION
ACCESSING THE BATTERIES AND MEMORY CARD
ALERT
Be sure the camera is turned OFF before opening and closing the battery / memory
card cover.
HOW TO INSERT AND REMOVE THE MEMORY CARD
The memory card is installed in the camera at the factory. Check that it is
properly set.
c
CAUTION
The memory card is a precision electronic component. Comply with the
instructions below to avoid damage.
❏
Don't touch the terminals with your fingers or metal. Resulting static
electricity could cause damage. Discharge body static electricity by
touching something metal before you handle the card.
❏
Don't bend, drop or otherwise shock the memory card.
❏
Keep the memory card away from water, excessive heat or direct
sunlight.
❏
Don’t break down or take apart the memory card.
Note:
You may also use a MultiMedia Card
You may use an SD memory card or a MultiMedia Card. (See pages 19, 53.)
Note:
The memory card must be removed when:
❏
you would like to copy images saved on the memory card to a computer.
❏
the printer has a memory card slot that you may use directly.
BATTERY SETUP
Be sure the battery poles + - are aligned properly.
c
CAUTION
If you insert the batteries incorrectly you may cause leaking, overheating
or injury to yourself. You may also damage the camera.
Opening the cover
Slide the Battery/Memory Card Cover
in the direction of the arrow while
pressing down on it.
Closing the cover
Slide the Battery/Memory Card Cover
in the direction of the arrow until it
clicks into place.
MEMORY CARD INSERTION
Checking that the card is facing the
right direction, slide it in until it clicks.
REMOVING THE MEMORY CARD
Release the card by pushing once and
then pull it out with your fingers. (Push
once to set it, push again to release it.)
SETTING THE BATTERIES
Insert the batteries according to the
pole indications on the cover.
Note:
To find out what batteries may be used. See
page 53.