Filter
Top Products
48
ADDITIONAL SETTINGS
REGISTER / DELETE SOUND DATA
You can take the same procedure to change both shutter sound and
photo-preparation sound.
1. Use the ud buttons and select a Shutter Sound, Focus Lock Sound or
Self Timer Sound.
2. Use the lr buttons and select the item to change.
You can select the item in the order as beep sound
➝
sound1
➝
sound2.
You can register sound1 and sound2.
3. Press the FLASH button.
The sound data registered in the camera body is displayed.
4. Use the r button and display the sound data in the memory card.
The next steps are all continued from step
5
.
Note:
If the sound data had the same name as one in the camera body, a message
on overwriting confirmation will be displayed. Press the FLASH button
to confirm the new sound with replacing the old sound of the same number.
REGISTER SOUND DATA
5. Use the ud buttons and select the sound data to register.
You can play the sound by pressing the REVIEW button.
6. Press the FLASH button.
A copy confirmation request message will appear.
If the camera is low on memory space, the new sound cannot be copied.
Delete the old sound first, then copy the new one.
7. Press the MACRO button.
The new sound is copied to the camera. To cancel this operation, press
the FLASH button.
DELETE SOUND DATA
If (in step 6 above) there was not enough memory space for new sounds,
delete the old sounds as follows;
5. Use the ud buttons and select the sound data to delete.
You can play the sound by pressing the REVIEW button.
6. Press the MACRO button.
A delete confirmation request appears.
7. Press the FLASH button.
The sound data is deleted.
AUTO POWER SAVE
When the camera is turned on but inactive for a period of time, the camera
automatically shuts down to save battery power.
2. When the camera is left in Sleep mode for over 10 minutes, it will shut
down automatically.
The lens will retract and the lens cover will close.
Turn the DIAL SWITCH to SET UP MODE and then
turn the POWER ON.
The SETUP menu will appear on the LCD monitor.
1. When there is no activity for over
3 minutes, the camera will enter
sleep mode.
While in Sleep mode, the green
light will blink. The LCD monitor
will turn off and the CPU will also
be in sleep mode.
Note:
To cancel Sleep mode, press the
SHUTTER button, or any other
button on the back of the camera. You
can also simply turn the DIAL
SWITCH.
LCD monitor
Indicator light (green)